Here’s a brief piece about placing your spool/bobbin in to the bobbincase of your Brother PR650. It’s just the same for the Brother PR600 & PR620. It’s only a guide and if you still aren’t sure how to fit your bobbincase, just phone or email for further help.
First, draw off 4 or 5 inches of thread from the bobbin, make sure the thread leaves the bobbin from the top.
Thread comes off the top of PR650 bobbin
Next, notice the fine slit on the body of your bobbincase. The thread will slide into this slit, later.
Brother PR650 bobbincase, thread slit.
Next, drop the bobbin into the bobbincase.
Brother PR650 bobbincase with bobbin inside.
Next, gently slide the thread into the slit.
Brother PR650 bobbincase threading
Next, gently pull the thread under the tension spring until it ‘clicks’ into place between the jaws at the end.
Brother PR650 bobbincase threaded
Next, take the bobbincase in your hands, holding the bobbin in place, and carefully open the latch about three quarters of the way open DO NOT force this latch. Then place the bobbincase inside your PR650.
Brother PR650 bobbincase
Next, gently place the bobbincase inside the raceway of your PR650. Make sure it goes all the way in, as shown. Leave about 2 or 3 inches of loose thread hanging from the bobbincase and then close the raceway door without trapping the thread.
Brother PR650 bobbincase in position
